![]() This will reset the switch to factory default settings. We do this by deleting the startup-config file and then reloading the switch as shown below: console> en The next step after connecting with the terminal emulator was to reset the switch to factory default settings. Reset Dell PowerConnect Switch to Factory Settings This should get you connected to serial console. You can see the settings below that I found configured in my Dell PowerConnect switch: console> show line You will need to configure your terminal emulator’s line settings to 9600,8,n,1. ![]() Typical terminal emulators are putty or hyperterm on Windows workstations. Next, find a terminal emulator that will recognize your serial port. ![]() You can see how it connects in the photo. For this task, I used my Tripp-Lite Keyspan USB serial adapter which I plugged into my USB port and then connected the serial cable to the 9 pin male end of the Tripp-Lite Keyspan adapter. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |